Tripp Lite Minicom Smart 108 Guia do Utilizador descarregar pdf (Página 26)

SMART CAT5 SWITCH

–

108/116

Input the DDC information of the monitor connected to the Smart CAT5 switch into

the memories of all connected RoC/RICCs when first installing system.

To input the DDC information:

1. Disconnect the Video cable of all RoC/RICCs from the computers.

2. Press Shift twice to open the OSD.

3. Press F10. “Please wait” flashes a few times and disappears. The monitor’s DDC

information is sent to all RoC/RICCs.

4. Reconnect the Video cable of all RoC/RICCs.

4.2.14.1 Updating the DDC information

Update the DDC information in any of the following circumstances:

· When replacing the monitor connected to Smart CAT5 Switch

· When adding a new RoC/RICC to the system

· When reconnecting an existing RoC/RICC that was temporarily used in a

different system

To update the DDC information, repeat the steps as set out above.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 44 45

Sem comentários

Tripp Lite Minicom Smart 108 Guia do Utilizador Página 26